The confirmation work for the new CX-5 (KF series-300001 ~), for which some parts were unconfirmed, has been completed.As a result, existing products can be installed except for some gasoline 2.5L turbo cars.I will tell you the details.

<The key to running, suspension>

In the new model, there are minor changes in the damper damping force and spring constant, and each part has been brushed up.However, for users who want a sporty ride, the feeling of high waist and glaring roll cannot be wiped out.

① Low down spring・ ・ ・ Installation OK

Compared to the conventional car, the spring is set slightly stiffer in the new model, and in some grades, the low down spring may have a slightly lower spring constant.However, as a result of the test, the taste of the roll, the vehicle height, and the connection at the time of bump touch are also good.Achieves a crisp and stable ride even with an SUV without an unpleasant push-up feeling.In addition, the gasoline turbo has almost the same weight as a diesel vehicle, so it has the same part number as that for diesel vehicles.

② Street Sports Suspension Kit & Sports Damper・ ・ ・ Installation OK

Since there is no change in the basic design and vehicle weight from the conventional type, it can be installed as it is.Control the roll speed from the moment the damper starts moving (very low speed range) such as winding.It is a specification that pursues the best street "ride".

* The genuine rear upper mount needs to be replaced separately.Please be careful.

③ Body reinforcement・ ・ ・ Installation OK

A tower brace set and a member brace set, which are full-scale reinforcement parts that solidify the key points of the body on the surface and ensure a crisp body rigidity.Gasoline turbo cars can also be installed without interference with auxiliary equipment and mufflers.

④ Intake and exhaust・ ・ ・ Diesel & Gasoline NA can be installed

The following three points will be newly developed for gasoline turbo cars.

■ Sports muffler　New design with a dedicated layout.It is necessary to take and pass the acceleration noise test to meet the safety standards.

■ Intake suction kit　Since the hose body has a new shape, we will design a new one.

■ Ram air intake system　The basic shape is the same as that of diesel vehicles, but the air-fuel ratio (ratio of air and fuel) is different, so special settings are applied.

We are planning to release it sequentially from next year.Please stay tuned!

⑤ Brake & utility etc.... Most of the parts can be installed!

For detailed conformity information,please use this form.Please verify.

Posted by J. Inazumi