Made of aluminum, following the design of AutoExe wheel nuts.

This is a dress-up item that is attached to air valves. The product follows the design of AutoExe wheel nuts and is made of aluminum with a red anodized finish, allowing you to enjoy total coordination. It gives a clean and sophisticated impression around the wheel by covering the brass threads that are exposed in mass-produced plastic caps. In addition, the AutoExe logo is laser engraved in two places on the side of the cap so that it can be seen no matter where it is tightened. It comes in a set of four for one vehicle.

■Covers the screw threads for a clean impression.

■Designed to resemble the details of wheel nuts.

■The AutoExe logo is laser engraved on two sides, so it can be seen no matter what position it is tightened in.

■It may not be possible to install this product on some commercially available wheels. Please check the clearance in the product dimension diagram.


<Product compatibility table>

■Air Valve Cap 1 pieces for 4 car

part number適合 車 種Tax-included price
(Price without tax)
Spec.CodesReference work
Time
C9A1 V3 820General purpose ※ 1¥ 4,400
(¥ 4,000)
Made of aluminum (A6061-T6), red anodized + clear coating, with AutoExe logo (on both sides)
L=18.0mm W=14.5mm irregular heptagon (4-sided) type for US valves, set of XNUMX 
D0.1h
※ 1 This product may not be compatible with some commercially available wheels. Please check the clearance in the product dimensions before purchasing.