KF-06
"I want to ride like a sports car even if it's an SUV." Again, it deepens the enjoyment of driving.The styling that expresses the neat strength woven by the blacked-out markless grille, front under & rear roof spoiler, and four left and right sports mufflers combined with the exclusive garnish brushes up the form of the base car, and other CX It insists on the intention to run, which is clearly different from -06.
Styling kit
Front under spoiler
An additional type that can be attached to a mass-produced front bumper to visually realize a low form.The wedge shape at the tip of the wing, which is an accent, adds a flowing power to the CX-5.Piano black painted.
Front grill
A simple markless grill that expresses neatness and power.Piano black is applied to the surface and matte black is applied to the recesses to emphasize the three-dimensional form.Trade-in with mass-produced grills.
Muffler garnish
The combination of the dual tail with four left and right and the exclusive muffler garnish makes the rear view look fearless.
Rear roof spoiler
Wing type that tightens the rear view.The wedge shape at the tip of the wing, which aims for total coordination with the front under spoiler, enhances the sense of dynamism.Piano black painted.
Sports side visor
A high-performance side visor with a ventilation mechanism in addition to rain and sun protection.When the recommended side window is open, the negative pressure generated during driving is used to actively discharge the indoor air.At the same time, it also has the effect of preventing the ingress of rainwater.
LED rear combination light
The previous model CX-5 has been updated to full LED specifications.Equipped with a high-intensity red light bar with a horizontal tone, a sequential turn signal that gives an impact to the following vehicle and enhances visibility (wiring can be switched in a blinking manner), and a light smoked lens, the rear view has been renewed to a clean and neat rear view.
※ 1 For installation, genuine tape (KB9W-51-9N6) x 2, clip (KB8A-51-SJ3) x 2 are required separately.
The product is compatible with each safety equipment such as millimeter wave radar (SBS / MRCC), but it may not operate properly depending on the weather and driving conditions as well as mass-produced vehicles.
Product name | 適合 車 種 | part number | Tax-included price (Price without tax) | Spec. | Codes | Reference work time |
---|---|---|---|---|---|---|
Front under spoiler | KF series-~ 499999 | MKG2100-08 | 85,800JPY (¥ 78,000) | FRP piano black painted drilling required | D | 0.8 h |
Front grill | KF series-~ 499999 360 ° view monitor equipped car KF series-~ 499999 360 ° view monitor non-equipped vehicle | MKF2500 MKG2500 | sold out. 68,200JPY (¥ 62,000) | Piano black / matte black 2 colors painted ABS resin ※ 1 | D | 1.0 h |
Muffler garnish | KF series-~ 499999 | MKF2410 | 30,800JPY (¥ 28,000) | For vehicles with sports muffler (MKF8Y70 / 8Y80) Cannot be installed separately AES black satin finish (no painting required) Rear bumper excision required | D | 1.0 h |
Rear roof spoiler | KF series-~ 499999 | MKF2600-08 MKF2600 | 85,800JPY (¥ 78,000) 46,200JPY (¥ 42,000) | AutoExe Ornament included FRP Piano Black Painted Drilling required Includes AutoExe ornament Made of FRP Painting required Drilling required | D | 1.0 h |
Sports side visor | All cars | KFA1 V3 700 | 26,400JPY (¥ 24,000) | Smoke acrylic resin 4 piece set with ventilation mechanism | D | 0.5 h |
LED rear combination light | KF series-~ 499999 ※ 2 | KFA1 V4 630 | ¥145,200 (¥ 132,000) | Light smoked lens LED red light bar LED sequential turn signal (flashing type selectable) Made by Valenti * Safety standard compliant product (E9-11077) | F | 2.7 h |
※ 1 A part of the front grill may be reflected on the screen of the front monitor.Also, when installed on a vehicle with a 360° view monitor, it may be necessary to adjust the aiming of the camera.
※ 2 For installation, genuine tape (KB9W-51-9N6) x 2, clip (KB8A-51-SJ3) x 2 are required separately.
KF-05S
A full bumper type that pursues original styling.The trapezoid grille, which has both a markless face and millimeter-wave radar function, and the bumper duct, which is blacked out in the horizontal tone, create a wide and stable front view.At the rear, the center dual muffler and the rear roof spoiler are daringly tightened.Compatible with models before face lift.
Styling kit
● The tires and wheels in the photo are examples of installation.
The product is compatible with each safety equipment such as millimeter wave radar (SBS / MRCC), but it may not operate properly depending on the weather and driving conditions as well as mass-produced vehicles.
Product name | 適合 車 種 | part number | Tax-included price (Price without tax) | Spec. | Codes | Reference work Time |
---|---|---|---|---|---|---|
Front bumper & grill | KF system ~ -449999 ※ 1 | MKF2F00 | ¥115,500 (¥ 105,000) | Bumper grill integrated millimeter wave radar (SBS / MRCC) compatible Genuine headlamp washer can be installed FRP (grill part: PP) painting required Drilling required Genuine fog lamp tow hook cannot be installed | D | 1.0 h |
Rear under panel | KF series ~ -199999 Diesel car / gasoline 2.5L car | MKF2400 | ¥44,000 (¥ 40,000) | Premier tail muffler Center dual (MKF8Y50 / 8Y60) for vehicles equipped with FRP painting required Not separately installed Required rear bumper excision processing | D | 1.0 h |
Rear roof spoiler | KF series-~ 499999 | MKF2600 | ¥46,200 (¥ 42,000) | Includes AutoExe ornament Made of FRP Painting required Drilling required | D | 1.0 h |