Adjustable link that is indispensable for stabilizer at low down.

As you know, the stabilizer connects the left and right suspension arms and suppresses the roll by the spring effect.The part that connects the stabilizer and suspension arm (or damper) is the "stabilizer link".Since the length of the link at the stabilizer end of a mass-produced vehicle is designed based on the mass-produced vehicle height, the arm angle between the stabilizer body and the stabilizer link becomes sharper than the appropriate value when the vehicle height changes when the angle of the lower arm changes. , There is a tendency to spoil the original stabilizer effect.Adjustable (adjustable) stabilizer link is an item that optimizes the arm angle by adjusting the link length and restores the original function of the stabilizer.We are developing a lineup of a wide range of vehicle models in order to meet the demands of users who want to be thoroughly committed to reliable handling.It is recommended to install the lowdown spring at the same time.

Operation diagram (conceptual diagram) in which the input from the road surface is transmitted to the stabilizer via the link.

At the time of mass production vehicle height

The mass-produced stabilizer link is designed to have a length that matches the height of the mass-produced vehicle. (The angle between the stabilizer and the link is almost right angle)

At lowdown

Pushed by the arm, the angle between the stabilizer and the stabilizer link becomes an acute angle.

When AJ stabilizer link is installed

By adjusting the total length of the link, the angle between the stabilizer and the stabilizer link is corrected.

Difference in adjustable stabilizer link mounting method

Push type

In a vehicle model in which the fulcrum of the link is attached in the downward direction (for example, the lower arm), the stabilizer link is pushed from the lower side when it is lowered, so the arm angle is corrected by shortening the link length.
(For RX-8/Roadster/CX-60, etc.)

Pull type

In a vehicle model in which the fulcrum of the link is attached in the upward direction (for example, the damper body), the stabilizer link is pulled from the upper side when it is lowered, so the arm angle is corrected by increasing the link length.
(For MAZDA2 / MAZDA3 / CX-5, etc.)

<Product compatibility table>

■ Adjustable Stabilizer Link　Full length adjustable left and right set of 2