Sorry I made you wait!To the new Atenza released the other dayThe first list of existing products is releasedWas.

This time, we will mainly introduce parts that are often requested to be installed on new cars at the same time.
① Low down spring
A new model with optimized suspension parts as well as damper and spring settings.Starting from whether or not it can be installed on the desk, check the vehicle height on the developed vehicle.As a result of conducting driving evaluations of handling and ride quality, we have made it possible to install existing products for both diesel and gasoline vehicles.

Polish your styling with a vehicle height of -20mm compared to mass-produced vehicles! Regarding "ride quality", we emphasized the setting and damping ratio (balance between spring constant and damper damping force) in combination with the spring and bump stopper.The new model has a slightly stiffer impression than the conventional model ... There are cases where the low-down spring has a slightly lower spring constant, such as 4WD vehicles, but I think we were able to achieve natural handling with less push-up feeling. increase.Product detailsplease use this form..
② Body reinforcement parts
In the new model, the thickness of the cross member has been increased and the shape of the gusset (reinforcing material) has been changed, but we have confirmed the installation of four points: the strut tower bar, center floor bar, floor cross bar, and lower arm bar (tower brace set).・ Member brace set is unconfirmed).
In combination with a low-down spring, you can enjoy even sharper handling.

Other,Street Sports Suspension Kit,Street sports brake pads,Sports side visor,Shift knobProducts such as can be installed!

_ _

For reference, I will explain some of the products that could not be installed ...

① Premier tail muffler
The new model has a different engine and a different muffler tail shape, so it cannot be physically installed.We will develop new exclusive products for both diesel and gasoline vehicles.

② Street brake rotor
Only the front of diesel vehicles has a larger rotor diameter, so it cannot be installed.

③ Bonnet damper
It cannot be installed because it overlaps with the pop-up bonnet (pedestrian protection system) installed in all vehicles.In addition, there are no plans for new development at this time as it may affect the operation of the system.

Unconfirmed conformity information will be updated as soon as it is confirmed.In addition, the GJ-06 tuning kit is scheduled to be released in September.
Please wait a moment now!

Posted by T.Takechi